Swinging arm bushes

› Forums › Technical › Two Stroke: Help needed › Swinging arm bushes

Viewing 1 reply thread
  • Author
    Posts
    • January 19, 2016 at 8:26 pm #6383
      Anonymous
      Inactive

      Help Needed – I am fitting new rubber bushes to the Swinging arm of my ETZ 251 – is it easier to insert the rubber bush first and then the bearing sleeve or push it in bush and sleeve as one – any one done it before who can offer advice or even direct me to were i can by the MZ special tools – i am reasonable mechanicly able – hence why i am asking for advice before i start…..ian

    • January 22, 2016 at 10:03 pm #6401
      Markus Ensslin
      Participant

      hi –

      the only way i managed to fit these was using a vice. first insert the rubber outer by about a long 1/4 or a short 1/3, then insert the inner sleeve and press both in.

      g max ~:)

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.