seat problem

› Forums › Technical › Two Stroke: Hints and Tips › seat problem

Viewing 5 reply threads
  • Author
    Posts
    • August 24, 2015 at 7:52 pm #5745
      Anonymous
      Inactive

      Hi people,
      Got an ES250/2 project with no seat,
      Does anyone know if the seats from any other mz models would fit, maybe a ts seat??
      Thanks for any help, Mark

    • August 24, 2015 at 8:04 pm #5746
      Anonymous
      Inactive

      Hi Mark. Funnily enough I am trying to source a replacement seat/seat cover for my TS250. If it helps I could measure the distances between the four frame lugs and let you know? Wayne

    • August 25, 2015 at 9:05 am #5749
      Anonymous
      Inactive

      Thanks Wayne, that would be great.
      ATB, Mark

    • August 25, 2015 at 9:13 pm #5751
      Anonymous
      Inactive

      Hi Mark. I have done some measurements and have two photos of the frame rails and also a rather clumsy JPEG drawing with the dimensions on. I cannot see a way to load them on to this page so if you know how to do this let me know, or give me an email address instead and I will send on to you. If you don’t want to put your email address on this site then email me separately on waynerr@btinternet.com and I’ll send them over. The distance between the outer edge of the jaws across the frame is 205mm and along the length of the frame is 325mm. The internal width of each jaw is 10mm. Wayne

    • August 26, 2015 at 8:33 am #5757
      Anonymous
      Inactive

      Thanks Wayne, email in route……..

    • August 27, 2015 at 10:43 pm #5776
      Anonymous
      Inactive

      Hi Mark – not had an email from you. I go on holiday early on Saturday….

  • Author
    Posts
Viewing 5 reply threads
  • You must be logged in to reply to this topic.