Reply To: TS250/1 for tall riders?

Forums Technical Two Stroke: Hints and Tips TS250/1 for tall riders? Reply To: TS250/1 for tall riders?

#13867
Brian
Participant

James

Time’s not the issue, it’s remembering.

Anyway here’s my measurements and bear in mind that rotating the bars will change the dimensions a bit.
All dims in mm and approximate

Flat Bars:
Width: 600mm
Offset horizontally: 100mm – Straight edge across ends of bars and measured to the centre of the handlebar between the clamps.
Offset Vertically: 25mm – The bars are essentially flat so measurement depends on your preference. I’ve not ridden this bike but all felt OK when sitting on it.

Raised Bars:
Width: 740mm
Offset horizontally: 90mm – Straight edge across ends of bars and measured to the centre of the handlebar between the clamps. This can be increased/decreased by rotating the bars but will change the angle, both horizontally and vertically of the grips. Nothing a vise and some scaffolding pipe won’t resolve:) This is OK for me at 5′ 10″. This is less accurate than the measurement taken of the flat bars if you need a more accurate measurement just let me know.
Offset Vertically: 100mm

Anything else just ask.

Brian